View All Categories

IMO, absolutely no need to spend $300-$400 for a set of bolt in or 3M double sided tape set of outer grille guards. These are top quality, black powder coated aluminum and match the factory mesh grilles on the C8. Do yourself a favor and drop a few extra $$$ and order 9-10 (allows for some cutting mistakes) feet of the rubber trim to go around these guards...worth every penny and gives peace of mind when installing without worrying about damaging the radiator fins.

Great product, easy install. Thanks for having a YouTube video to show how it’s done and make it easy. It looks great and doesn’t block too much air. I took the museum delivery of my car down in Kentucky. I carried my grill covers on the plane and installed them The motel I stayed at. It’s a great looking product and it does the job. I don’t have any rock dents in my radiators

Tough to get your hands in there...
It's better is you can raise the car.

Fit is very good. Installation was performed by Chevrolet tech.

This should be on every new C8 owners first upgrade list. Simple project requiring only a few hand tools.

The precut screens fit well into the bumper openings, and the mesh pattern matches the rear diffuser grille giving it a OE look. Highly recommend this while your C8 is new before the radiators get dinged up by bugs and debris.

They fit right and are metal, exactly like the inserts for airflow out of the engine compartment. So that is what they look like.

The zip ties are a bear to put in at the top where you can't reach in and guide them. Bend the end of the zip ties and be patient. the small hole size makes it a bit difficult, but they protect better and make for a darker appearance -- looks great.
there is a cutout for the frunk opener, but the rubber protector falls off. I used fishing line to tie it on.

I belong to the mid-engine corvette forum and there is a manufacturer selling a similar product that mounts up front over the grill piece for over $300. Don't get it. These do the same thing and won't fall out or block your frunk opener.
You might also put some good SiO2 wax or extra ceramic coating if you have some around, on them to make them wash off easier.

Nothing to dislike. Saves your radiator and a/c coils from rocks and insects. Well...not the little bitty insects. They won't do that again..

Great quality finish on the grill. Just be careful of the sharp edges during install! Thankfully they included more than enough of high quality zip ties. Installed product looks clean as long as you zip tie in the right locations, you can't even see them. Job took about 1.5 hours mostly because of the 16-20 screws that you have to remove and reinstalled. Not difficult, just time consuming. If you have a car lift or ramp, you installation would be much easier...I just activated my front axle lift and that was sufficient. God help you if you don't have any of those methods to raise you car a little.

Getting the grills in without bending them or damaging the fragile radiator was a challenge. Again, not too difficult, just work with you angle of entry and be patient! Overall, not a difficult mod...VERY please with how it looks and definitely will protect the radiator!

Good quality and look great on my car. You could make your own, but materials and time would cost more. They're are not as quick to install as you would expect. Suggest using a modified dental tool hook to feed the zip ties back through the grill. Check out the Corvette Forum for great installation photos and advice. Can't imagine not using jacks or a car lift to do the installation.

Installed on my 2020 Corvette as a rock guard

Looks great, fairly easy to install. Wish maybe other grill openings were included.

There is definitely a design flaw with air intake on the C8. I wish I had put these grills on before I drove it anywhere. I installed with out ramps but did take advantage of slight decline in driveway. There are 6 7m bolts and about 20 T15 screws. Turned out great. Highly recommend

Material Great

Great product and performs perfectly to protect your C8 radiators. Easy to install without jacking up your Corvette and they were very well packaged for shipping without damage.

Fast Service great value

I had to rock things in my radiators prior to installing the guards. After they are working very well I have no new rock things in my radiator.

Installation was easy since I have a lift, and with the car up in the air it is easy to install these. if you do not have a lift taking off the under panels on the car would be a little more time consuming.

These mesh grill sets are amazing and match the car perfectly. After I installed them they look like stock grills. I had to pull the car up on ramps, this made the job 100% easier. There are lots of screws and bolts holding the bottom covers in place. Taking pictures of the setup before I started made reassembly a lot easier.

It’s very nice. Works great so far.
Maybe a new model with smaller holes in the mesh next time if it doesn’t interfere with air flow.

The grills were properly cut, easy install. Seller portrayed item well.

The grills were properly cut, easy install. Seller portrayed item well.

Great value compared to competitors

This grill looks great on my black 2020 C8. The car has about 1200 miles on it and the accumulation of road trash inside the front end was mind boggling. These new grills will stop that as well as eliminate future damage to the radiator and A/C condenser fins. Well worth the time and cost to buy and install.

Top quality product/ Quick delivery.

Not too hard to install if you can get the car up on a lift. Working on the ground may be a bit more challenging but not impossible.

High quality mesh set to protect your C8 Corvette. Accurate cut/shapes, and typical "behind the grill" installation. Still waiting for someone to produce a "front-mount" version that clips onto the existing grills and can be easily removed for cleaning and track day use.

Watch the video and it'll explain how to install it. Not a hard job.

This Honeycomb Mesh Grill Set is an inexpensive addition to a Stingray C8 that will help to protect the exposed radiators from projectiles. Well worth the cost and install effort or expense. I had mine installed by a custom body shop, which cost me an extra $150, but I preferred having someone else do it. Just make sure to put several zip ties all around so that the mesh stays firm and secure. After the install, you can barely notice any difference and the black color fits perfectly with the overall look. The zip ties around the grill are not noticeable. Overall, an inexpensive addition to provide some peace of mind against damage to radiators. Chevrolet should install this type of mesh grill, instead of owners having to go to the trouble of getting them installed.

Looks great on the C8. Helps protect the radiator from rocks.

I had someone install, so I don't know how difficult. They are amicably invisible. They blend in perfectly. I don't know if they hold up and do the job as they were just installed

Good quality.