This is a mesh grill piece for a Hyundai Genesis from 2013-2016. Our mesh is fully pre-cut and pre-bent and ready to install in the factory bumper after the center area has been cut out (as shown in our video installation).
Only the mesh piece is being sold, and modification of the factory bumper is required for installation. The fog light mesh option is only available for models with the all plastic mesh version of that section (no fog lights equipped).
Please note: Some owners have experienced difficulties re-installing the bumper after mesh install; and in some circumstances the mesh needs to be pushed forward to clear the crash bar for bumper re-installation.
Please click on the other tabs for more information.
Do you have this available with a tow hook cutout?
Not yet. For now, that is something the installer will need to cutout in the mesh. We don't know the exact positioning for it right now. It might be something we could make in the future but we'll need a Genesis Coupe here to test the positioning.
What's the deal with the tight fit on the bumper re-installation?
We're not entirely sure what's going on with that. There's no rhyme or reason as to who it affects or why.
Thus far the best constructive comment we've had from an owner that had seen the issue first hand is "I am pretty sure this was caused from the initial install of the grill which probably deformed the bumper slightly and makes it really difficult to put back on. I had to put on the bumper sides first, then pull the top over the clips and then the bottom. No removal of the bumper bar or any grinding to anything. Don't crank down the zip ties as this is where the deformation occurs."
What is the adhesive that was used in the installation video?