These pieces are extra pieces that can add our mesh style to the 3rd gen Tacoma hood, headlight, & fog light areas. Installation is simple and installation hardware is included.
These are laser cut and made in the USA. The fog light pieces do not span the full width of the lower bumper, there is a break between them where the stock bumper is open and often used for a light bar.
Click To Launch Customer Gallery
Grill Mesh
Mesh Thickness:
0.065" / 14 Gauge
Country of Origin:
U.S.A.
Does this replace the factory pieces for these areas?
No, these are overlays on top of the factory areas.
Do I need to cut or drill my factory components to install these mesh pieces?
Yes, drilling is needed on all of the pieces. Please view the installation instructions for more info.
What is the mesh style that is used for this mesh set?
We laser cut the mesh to emulate the look of the Perforated SS mesh which is
available here if you are looking to either make your own mesh pieces or add-on more mesh.
Can I get this cut from a different mesh pattern?
Yes, it's technically possible but typically cost prohibitive to do so.
Can I get a set in gloss black?
At this time we are only offering a flat black finish.
